Showing 313–324 of 774 results

DS3231S – IC

290.00
DS3231 IC is a low-cost, extremely accurate I?C real-time clock (RTC) with an integrated temperature compensated crystal oscillator (TCXO) and crystal. The device incorporates a battery input and maintains accurate timekeeping when the main power to the device is interrupted. The integration of the crystal resonator enhances the long-term accuracy of the device as well as reduces the piece-part count in a manufacturing line. The DS3231 is available in commercial and industrial temperature ranges and is offered in a 16-pin, 300-mil SO package.

DS34T108GN+

9,792.00
Features of DS34T108GN+
  • Fully Equipped IC includes 10/100 MAC, TDMoP Engine, and E1/T1 LIUs and Framers.
  • Transport of STS-1 TDM or Other CBR Signals Over Packet Networks or E1, T1, E3, or T3
  • SAToP, CESoPSN, TDMoIP AAL1, HDLC, Unstructured, Structured, and Structured with CAS Mapping Methods; Adaptive Clock Recovery, Common Clock, External Clock, and Loopback Timing Modes; and Full Support for These Mapping Methods.
  • One-per-port, independently programmable On-Chip TDM Clock Recovery Machines.
  • Network PDV, Packet Loss, Constant Delay Changes, Frequency Changes, and Other Impairments are Handled by the Clock Recovery Algorithm.
  • 64 Independent Bundles/Connections
  • Supports IPv4, IPv6, UDP, RTP, L2TPv3, MPLS, and Metro Ethernet Multiprotocol Encapsulation
  • Support for VLAN in accordance with 802.1p and 802.1Q Support for MII/RMII/SSMII in the 10/100 Ethernet MAC
Application? of DS34T108GN+
  • Extension of TDM Circuit Over PSN:
  • PSN Leased-Line Services
  • GPON/EPON Over TDM
  • Over Cable TDM
  • Over Wireless TDM
  • Backhaul Over PSN for Cellular
  • Multiple Services through a Single PSN
  • Transporting HDLC-Based Traffic Over PSN

DS75176

16.00

In addition, it is compatible with RS-422. The driver and receiver outputs feature TRI-STATE capability, for the driver outputs over the entire common mode range of 12V to ?7V. Bus contention or fault situations that cause excessive power dissipation within the device are handled by a thermal shutdown circuit, which forces the driver outputs into the high impedance state. DC specifications are guaranteed over the 0 to 70?C temperature and 4.75V to 5.25V supply voltage range.

DS75176 RS-422/RS-485 Interface IC DIP-8 Package

45.00
The DS75176B is a high speed differential TRI- STATE@bus/line transceiver designed to meet the requirements of EIA standard RS485 with extended common mode range (+12V to ?7V), for multipoint data transmission.

DS8921 Differential Line Driver and Receiver Pair IC DIP-8 Package

155.00
The DS8921 device are differential line driver and receiver pairs designed specifically for applications meeting the ST506, ST412, and ESDI disk drive standards. In addition, these devices meet the requirements of the EIA standard RS-422.

Fan7390MX SMD

162.00
The FAN7390 is a monolithic high? and low?side gate?drive IC, which can drive high speed MOSFETs and IGBTs that operate up to 600 V. It has a buffered output stage with all NMOS transistors designed for high pulse current driving capability and minimum cross?conduction. ON Semiconductor?s high?voltage process and common?mode noise canceling techniques provide stable operation of the high?side driver under high dv/dt noise circumstances. An advanced level shift circuit offers high?side gate driver operation up to VS = ?9.8 V (typical) for VBS = 15 V

FAN7392 High and Low-Side Gate-Drive IC DIP-14 Package

120.00
The FAN7392 is a rnonolithic high- and low-sde gate drive IC that can drive high-speed MOSFETs and IGBTs that operate up to +600V. It has a buffered output stage with all NMOS transistors designed for high pulse current driving capability and minimum cross-conduction.

FT232 USB UART IC

303.00

Features of FT232

  • Single chip USB to asynchronous serial data transfer interface.

  • Entire USB protocol handled on the chip. No USB specific firmware programming required.

  • Fully integrated 1024 bit EEPROM storing device descriptors and CBUS I/O configuration.

  • Fully integrated USB termination resistors.

  • Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.

  • Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232) at TTL levels.

  • 128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.

FT232RL (SMD SSOP-28 Package) USB to Serial UART Interface IC

195.00
The FT232RL is the latest device to be added to FTDI?s range of USB UART interface Integrated Circuit Devices. The FT232R is a USB to serial UART interface with optional clock generator output and the new FTDIChip-ID? security dongle feature.

FT245RL (SMD SSOP-28 Package) USB To Parallel FIFO Interface IC

335.00
The FT245RL is a USB to parallel FIFO interface with the following advanced features:-?Single chip USB to parallel FIFO bidirectional data transfer interface.Entire USB protocol handled on the chip.

H11A1 OPTOCOUPLER 6 PIN IC

53.00
The H11A1 is an industry standard single channel photo transistor coupler. The optocoupler consists of gallium arsenide infrared LED and a silicon NPN photo transistor.

H11AA1 OPTOCOUPLER 6 PIN

32.00
The H11AA1 is a bi-directional input optically coupled isolator consisting of two inverse parallel gallium arsenide infrared LEDs coupled to a silicon NPN photo transistor in a 6 pin DIP package.