Showing 1–12 of 33 results

4N25

30.00
Features Response Time (tr : TYP,3 s at VCE=10V, IC=2mA, RL=100 ) UL approved (No. E113898) TUV approved (No.R9653630) CSA approved (No. CA91533-1) FIMKO approved (No. 193422) NEMKO approved (No. P96103013) DEMKO approved (No. 303985) SEMKO approved (No. 9646047/01-30) VDE approved (No. 094722 ) Options available : -Leads with 0.4"(10.16mm)spacing (M Type) -Leads bends for surface mounting(S Type) -Tape and Reel of Type I for SMD(Add"-TA"Suffix) -Tape and Reel of Type II for SMD(Add"-TA1"Suffix) -VDE 0884 approvals (Add"-V"Suffix) Applications 1. I/O interfaces for computers. 2. System appliances, measuring instruments. 3. Signal transmission between circuits of different potentials and impedances.

4N33

58.00
DESCRIPTION The 4N32 and 4N33 are optically coupled isolators with a gallium arsenide infrared LED and a solicon photodarlington sensor. Switching can be achieved while maintaining a high degree of isolation between driving and load circuits. These optocouplers can be used to replace reed and mercury relays with advantages of long life, high speed switching and elimination of magnetic fields. FEATURES • Very high current transfer ratio, 500 % min. • High isolation resistance, 1011 Ω typical • Standard plastic DIP package

4N35 OPTOCOUPLER

13.00
The 4N35 optocoupler consists of gallium arsenide infrared LED and a silicon NPN phototransistor. The couplers are Underwriters Laboratories (UL) listed to comply with a 5300 VRMS isolation test voltage.

6N135 OPTOCOUPLER (HIGH SPEED)

25.00
The 6N135 is an optocouplers with a GaAIAs infrared emitting diode, optically coupled with an integrated photo detector which consists of a photo diode and a high-speed transistor in a DIP-8 plastic package. Signals can be transmitted between two electrically separated circuits up to frequencies of 2 MHz.

6N136 OPTOCOUPLER

24.00
The 6N136 is an  optocoupler with a GaAIAs infrared emitting diode, optically coupled with an integrated photo detector which consists of a photo diode and a high-speed transistor in a DIP-8 plastic package. Signals can be transmitted between two electrically separated circuits up to frequencies of 2 MHz.

6N137 OPTOCOUPLER

25.00
The 6N137 are single channel 10 MBd optocouplers utilizing a high efficient input LED coupled with an integrated optical photodiode IC detector.

6N138 OPTOCOUPLER

31.00
The 6N138 consists of a GaAℓAs infrared emitting diode coupled with a split-Darlington output configuration. A high speed GaAℓAs Ired manufactured with an unique LPE junction, has the virtue of fast rise and fall time at low drive current.

6N139 OPTOCOUPLER

28.00
6N139 High Speed Opto-coupler is High common mode transient immunity and very high current ratio together with 5300 VRMS insulation are achieved by coupling and LED with an integrated high gain photo detector in an eight pin dual-in-line package.

A 3982 SLBT

400.00
FEATURES AND BENEFITS ▪ Low RDS(on) outputs ▪ Automatic current decay mode detection/selection ▪ Mixed and Slow current decay modes ▪ Synchronous rectification for low power dissipation ▪ Internal UVLO and thermal shutdown circuitry ▪ Crossover-current protection

A4506 HCPL4506 Optocoupler IC Gate Drive

100.00
The HCPL-4504 contains a GaAsP LED. The LED is optically coupled to an integrated high gain photodetector. The HCPL-4504 series has short propagation delays and high CTR. The HCPL-4504 series also has a guaranteed propagation delay difference (tPLH-tPHL). These features make the HCPL-4504 series an excellent solution to IPM inverter dead time and other switching problems.

CNY17-2 Optocoupler IC DIP-6 PIN

16.00
CNY17-2 Phototransistor IC with 10mA and 150mW Electrical Rating is an optically coupled pair consisting of gallium arsenide infrared emitting diode optically coupled to a silicon NPN phototransistor. Signal information, including a DC level can be transmitted by the device while maintaining a high degree of electrical isolation between input and output.