Ds34T108Gn+
Ds34T108Gn+
Click to enlarge
PN553A1EV/C102Y
PN553A1EV/C102Y ₹348.00
Back to products
SN74LVC1T45DCKR
SN74LVC1T45DCKR ₹34.00

DS34T108GN+

₹9,792.00

Features of DS34T108GN+

  • Fully Equipped IC includes 10/100 MAC, TDMoP Engine, and E1/T1 LIUs and Framers.
  • Transport of STS-1 TDM or Other CBR Signals Over Packet Networks or E1, T1, E3, or T3
  • SAToP, CESoPSN, TDMoIP AAL1, HDLC, Unstructured, Structured, and Structured with CAS Mapping Methods; Adaptive Clock Recovery, Common Clock, External Clock, and Loopback Timing Modes; and Full Support for These Mapping Methods.
  • One-per-port, independently programmable On-Chip TDM Clock Recovery Machines.
  • Network PDV, Packet Loss, Constant Delay Changes, Frequency Changes, and Other Impairments are Handled by the Clock Recovery Algorithm.
  • 64 Independent Bundles/Connections
  • Supports IPv4, IPv6, UDP, RTP, L2TPv3, MPLS, and Metro Ethernet Multiprotocol Encapsulation
  • Support for VLAN in accordance with 802.1p and 802.1Q Support for MII/RMII/SSMII in the 10/100 Ethernet MAC

Application  of DS34T108GN+

  • Extension of TDM Circuit Over PSN:
  • PSN Leased-Line Services
  • GPON/EPON Over TDM
  • Over Cable TDM
  • Over Wireless TDM
  • Backhaul Over PSN for Cellular
  • Multiple Services through a Single PSN
  • Transporting HDLC-Based Traffic Over PSN

2490 in stock

Add to wishlist
SKU: CMC-0048 Category:
Description

Description of DS34T108GN+

Up to eight E1, T1, or serial streams or one high-speed E3, T3, STS-1 or serial stream may be transparently transmitted over IP, MPLS, or Ethernet networks using these IETF PWE3 SAToP/CESoPSN/TDMoIP/HDLC compliant devices. Recovered clocks’ jitter and wander adhere to G.823/G.824, G.8261, and TDM requirements.

Up to 64 independently customizable bundles can carry TDM data. Except for AAL2, all standards-based TDM-over-packet mapping techniques are supported. Additionally supported are frame-based serial HDLC data transfers. has fully functional E1/T1 frames and LIUs built in.

These ICs preserve the ability to use TDM streams at crucial intermediary points while encapsulating the TDM-over-packet solution from analogue E1/T1 signal to Ethernet MII. The DS34T10x devices’ high level of integration reduces cost, board space, and time to market.

 

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “DS34T108GN+”

Your email address will not be published. Required fields are marked *

Shipping & Delivery

MAECENAS IACULIS

Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.

ADIPISCING CONVALLIS BULUM

  • Vestibulum penatibus nunc dui adipiscing convallis bulum parturient suspendisse.
  • Abitur parturient praesent lectus quam a natoque adipiscing a vestibulum hendre.
  • Diam parturient dictumst parturient scelerisque nibh lectus.

Scelerisque adipiscing bibendum sem vestibulum et in a a a purus lectus faucibus lobortis tincidunt purus lectus nisl class eros.Condimentum a et ullamcorper dictumst mus et tristique elementum nam inceptos hac parturient scelerisque vestibulum amet elit ut volutpat.

Related products

Compare

CH376S USB Read Write IC

₹389.00

CH376 is used as file manage control chip, used to MCU system read/write file in USB Flash Drive  or SD card.

CH376 supports USB-Device Mode and USB-HOST Mode. Set the basic firmware of USB communication protocol in the inner. It is also set firmware of special communication protocol to  deal with Mass-Storage devices, communication interface firmware of SD card, FAT16, FAT32 and FAT12 file system manage firmware in the inner.

Add to wishlist
Add to cart
Quick view
Compare

CP2102 USB to TTL IC

₹203.00

The high-performance, low cost CP21xx USB to UART bridge family offers a complete plug and play interface solution that includes royalty-free driver suites and a comprehensive design ecosystem that enables customers to speed time-to-market. Crystal-less operation, in-system programming memory and small body size packages reduce cost, simplify design and shorten development time. The CP2102 is a highly-integrated USB-to-UART Bridge Controller providing a simple solution for updating RS-232 designs to USB using a minimum of components and PCB space. The CP2102 includes a USB 2.0 full speed function controller, USB transceiver, oscillator, EEPROM or EPROM, and asynchronous serial data bus (UART) with full modem control signals in a compact 5 x 5 mm QFN-28 package.

Add to wishlist
Add to cart
Quick view
Compare

MAX485 IC

₹92.00

Each part contains one driver and one receiver. The driver slew rates of the MAX485 is not limited, allowing them to transmit up to 2.5Mbps. All parts operate from a single 5V supply.The driver is short-circuit current limited and  protected against excessive power dissipation by thermal shutdown circuitry that places the driver outputs into a high-impedance state. The receiver input has a fail-safe feature that guarantees a logic-high output if the input is open circuit. The MAX485 is designed for half-duplex applications.

Add to wishlist
Add to cart
Quick view
Compare

P6KE150CA TVS Diode

₹7.00

The P6KE Series diodes is designed specifically to save your circuit from this sudden spike in voltage. P6KE Series diode are a very good Transient Voltage Suppressor (TVS) Diode. P6KE TVS Diodes are rated at 600 Watts and protects the sensitive electronic devices from the voltage spikes induced on circuit.

The characteristic of a P6KE TVS diode is that it respond to over voltages faster than other common overvoltage protection components such as varistors or gas discharge tubes. This makes TVS diodes useful for protection against very fast and often damaging voltage spikes.

Add to wishlist
Add to cart
Quick view
Sold out
Compare

LM2596S 5 Volts fixed Voltage Converter (TO-263)

₹48.00
The LM2596 series of regulators are monolithic integrated circuits that provide all the active functions for a step-down (buck) switching regulator, capable of driving a 1 Ampere load with excellent line and load regulation. These devices are available in fixed output voltages of 3.3V, 5V, 12V, and an adjustable output version.
Requiring a minimum number of external components, these regulators are simple to use and include internal frequency compensation, and a fixed frequency oscillator.
Add to wishlist
Read more
Quick view
Compare

MAX485ESA RS422 RS485 Interface IC

₹93.00

MAX485 is a low power transceivers for RS485 and RS422 communication. MAX485 contains one driver and one receiver. The driver slew rates of the MAX485 are not limited, allowing it to transmit up to 2.5Mbps.

These transceivers draw between 120µA and 500µA of supply current when unloaded or fully loaded with disabled drivers. MAX485ESA RS422 RS485 IC operates from a single 5V supply. Drivers are short circuit current limited and are protected against excessive power dissipation by thermal shutdown circuitry that places the driver outputs into a high-impedance state. The receiver input has a fail-safe feature that guarantees a logic-high output if the input is open circuit.

Add to wishlist
Add to cart
Quick view
Compare

HT12E

₹39.00

The 212 decoders are a series of CMOS LSIs for remote control system applications. They are paired with Holtek s212 series of encoders (refer to the encoder/decoder cross reference table). For proper operation, a pair of encoder/decoder with the same number of addresses and data format should be chosen.

The decoders receive serial addresses and data from a programmed 212 series of encoders that are transmitted by a carrier using an RF or an IR transmission medium. They compare the serial input data three times continuously with their local addresses. If no error or unmatched codes are found, the input data codes are decoded and then transferred to the output pins. The VT pin also goes high to indicate a valid transmission.

Add to wishlist
Add to cart
Quick view
Compare

MCP2200 USB 2.0 to UART Protocol Converter with GPIO

₹250.00

The device reduces external components by integrating the USB termination resistors. The MCP2200 also has 256 bytes of integrated user EEPROM.The MCP2200 has eight general purpose input/output pins. Four pins have alternate functions to indicate USB and communication status.

Add to wishlist
Add to cart
Quick view